The reason why people prefer the Dewalt miter saw is accuracy. Once it is no longer accurate, it will affect your cuts. When your miter saw is no longer accurate, it must have gone out of adjustment. You will need to re-adjust it. This is why this article gives you the necessary information on how to adjust a Dewalt miter saw.

Of course, manufacturers adjust miter saws before shipping them, but the saws sometimes go out of adjustment while in transit. Also, it is necessary to check the accuracy and adjust your miter saw at least twice a year. This will help you to get optimum performance from your saw all the time.

Dewalt Miter Saw Adjustments to Get More Accurate Cuts:

Cleaning

How to Adjust a Dewalt Miter Saw

The first step toward adjusting your miter saw is to clean it. If wood chips and sawdust build-up around the bevel, an adjustment will be difficult, if not totally impossible. So, you must clean it first. A good tool for that is an air compressor with an air nozzle for blowing. After blowing the dust away, you can wipe it clean with a wet piece of cloth.

When it comes to adjustment, the two components that should be adjusted are the fence and the blade. The blade should be 90-degrees to the table. If not, it requires an adjustment. Also, when there’s a gap between the table and the blade, you also need to adjust your blade.

How to Adjust the Blade?

How to Adjust a Dewalt Miter Saw

First Step: You need to loosen the bevel handle so that you can re-adjust it. Ensure you adjust it until the blade is in complete contact with the square.

Second Step: After establishing the contact, the next step is to tighten the handle very well.

Third Step: Remember, you loosened a bolt before you could loosen the bevel. Now, you should tighten the bolt. Continue to tighten it until it stops.

Whenever you adjust the bevel, you should ensure that it is always at 0-degrees.

How to Adjust the Fence?

How to Adjust a Dewalt Miter Saw

The fence should be 90-degrees to the blade. You should confirm this by putting the square against the fence. The blade and the edge of the square should be in contact. If there’s a gap between them, you have to adjust the fence using the following steps.

First Step: Find the two bolts that hold down the fence, you should loosen them. You can’t possibly adjust the fence without loosening it.

Second Step: Reposition the fence until it comes in contact with the blade. You need to do this slowly.

Third Step: You can now re-tighten the bolts that you loosened.

Fourth Step: Look for the bolts on the right as well. Loosen them, after that, determine the right alignment of the fence with the aid of a level. You have to keep adjusting it until both sides of the fence are aligned.

Fifth Step: Re-tighten the bolts, and that’s all.

Now you know how to adjust a Dewalt miter saw. We have broken it down into a few simple steps. It is necessary to check the accuracy and adjust your miter saw at least twice a year. The rule does not only apply to Dewalt miter saws. It is also applicable to other miter saws.